Project HARDIS – „Mechanical disintegration of hardwood“

 

Project HARDIS – „Mechanical disintegration of hardwood“

 

Project description and aim

Within the wood industry, a significant part of the processing processes, from roundwood processing to surface refinement, is based on mechanical disintegration. Increasing demands on process and resource efficiency lead to the fact that, in addition to the actual product, the resulting chips must have certain properties in order to be subsequently used as a raw material for the wood-based industry (chipboard, OSB, MDF, ...). However, due to the complexity of the material and the high speeds, the understanding of separation processes is still deficient. This lack of basic knowledge leads again to problems concerning a knowledge-based development of new tools as well as of process optimization measures. A further challenge arises from the fact that tools and processes are primarily designed for the processing of conifers. Due to climatic changes and the resulting conversion of the forest, however, an increased supply for hardwood is already to be expected. Thus, the wood industry and the wood processing industry are faced with the great challenge of counteracting changing raw materials in good time.

The goal of the HARDIS project is therefore to create the foundations for the machining of hardwood. In the course of the project, a new measuring method and measuring equipment will be developed to investigate cutting forces and deformation behavior at cutting speeds of up to 100 m/s. These data again provide the basis for the development of an FEM model. By combining the measured data, simulation using FEM and investigation of the failure mechanisms, a holistic understanding of the machining process will be an important result and the cutting process should be described by means of physically determined models.

Through cross-border cooperation and an interdisciplinary approach the project will help to raise the iterative process of technology development to a knowledge-based level.

 

Funding program:
Interreg V-A Austria-Czech Republic 2014-2020

 

Project-ID:
ATCZ21

 

Duration:
July 2017 – June 2020

 

Lead partner:
Mendel University, Brno – Department of Wood Science, Faculty of Forestry and Wood Technology

 

Project partner:
Kompetenzzentrum Holz GmbH – Area Wood Materials Technologies (WMT), Tulln

 

Project leader:
Stephan Frömel-Frybort

 

The project HARDIS – "Mechanical disintegration of hardwood" (ATCZ21) – is funded by the European Regional Development Fund and Interreg V-A Austria-Czech Republic 2014-2020 as well as by the province of Lower Austria.

 

For more information on the Interreg V-A Austria-Czech Republic 2014-2020 program, see:

www.at-cz.eu

 

For information on the HARDIS project visit the project website: www.at-cz.eu/hardis